ดร.ฟิคสิท ยูนิรีแพร์ เอฟซี DR. Fixit UniRepair FC

• Repair of damaged, debonded or weak concrete.
• Replacement of spalled, chipped or cracked concrete.
• The mortar is suitable where superior chloride and carbon dioxide resistance is required.
• Repair of vertical and overhead surfaces.
• Heavy concrete structural repair works

• The surface to prepared must be sound & clean It should be free of dust, loose mortars, oil, grease & coatings

• The voids diameter should be at least 30 mm bigger than the rod; the depth of the void should be 10 to 15 times the diameter of rod to be bedded. A few hours before bedding, fill the voids wirh water. Make sure that there is no residual water in the voids.
• Apply Dr.Fixit UniRepair FC as in the form of sound mortar by adding water.

• Make a solid formwork and ensure that the formwork is leak proof to avoid bleeding and leakage.
• Thoroughly wet the area and make sure that no residual water remains.
• Pour the Dr.Fixit UniRepair FC by a suitable method such as hand or pump.
• Care should be given to avoid air pockets while filling.
• Use ratio Water 16% of weight mortar.

• The repair areas must be clean and primed with Dr.Fixit Super Latex and allow 20 minutes for subsequent application of UniRepair FC.
• Dr.Fixit UniRepair FC can be applied at thickness in excess of 50 mm at a time no certical surfaces and up to 40 mm thickness when applied in overhead work. 

• Immediately after the completion of cleaning, apply the Dr.Fixit Epoxy Zinc Primer as a protective coat for steel. The priming system to be used on the concrete substrate will depend on the cause of the damage.
• Allow minimum 1 hour standing time between the application of Dr.Fixit Epxy Zinc Primer and yhe subsequent application of Dr.Fixit UniRepair FC.

• The decayed or damaged area of the concrete should be saw cut neatly keeping the side of the area as square as possible. Feather edging must be avoided. Test the surface for soundness; remove all loose debris, dust and water.

• Temperature range: 5 to 35 °C Outside this range, it is recommended to use hot mixing water (below 50 °C ) or cold water (above 50 °C) depending on circumstances, as well as increased care in protecting the surface (covering with insulating materials).
• Solid and resistance supports to be used. Support is to be saturated with water a few hours prior to installation. All residual water to be removed prior installation.
• Do not mix with other hydraulic binders. Under no circumstances should any additves be used.

• Shelf life is 12 months from the date of manufacturing. Store in a cool & dry place in unopened conditions.

• As with all chemical products, caution should always be exercised. Protective clothing, such as gloves and goggles, should be worm.
• Treat any contact to the skin or eyes with fresh water immediately . Should any of the products be accidentally swallowed, do not induce vimiting but all medical assistance immediiately.
• Ensure the pack is available for the medical attendant to examine any releant instructions and contents details.
• Reseal all containers after use and ensure product is stored as instructed

 *** ถ้ามีจำนวนขอราคาพิเศษ ติดต่อเราได้เลย ***