ดร.ฟิคสิท สกิมโค้ท พาวเดอร์ DR. Fixit Skimkote Powder

• For interior and exterior use
• Rendering mortar.
• Precast concrete.
• Any cementitious substrates.

• Substrate should be strong and cean, no dust or loose particles, oil stain, lubrication paste, concrete curing agent, or any material effecting adhesion property.
• Sprinkle water to moist the surface until saturated surface dry condition before working.
• Hole or crater defects should be repaired with suitable material and let it dry before rendering.

• Render Dr.Fixit Skimkote Powder ready mixture from above using a trowel spreading on the prepared substrate. It can be made several layers if needed.
• For the surface with more defects, render very thin layer using a trowel pressing against the surface to fill porous and small crak, and let it dry. At this step the surface finish may not be as smooth as required.
• After the first layer is dry, the seond leyer can be applied without sprishing any water on top.
• After the second layer, the surface should be smooth without any polishing required. If needed, can use fine sand paper to polish to satisfy the requuired

• Not requird.
• Before painting , should wait for Dr.Fixit Skimkote Powder to cure for about 7 days, depending on weather condition and thicknee of the layer.

• Clean the equipment with water immediately after finish working; wash your hand with soap and warm water.

• Working temperature isbetween 5 °C - 35 °C
• This product is not suitable for floor treatment or permanently immersed area, such as water Tanks.
• In high temperature and/or strong wind, wind, the fresh applied surface must be protected against rapid drying.

• Maximum 1 Year in sealed container kept under shed area. 

• Avoid skin and eyes contact. Can cause irritation to skin, eyes and respiratory system. In case of contact with eye, rinse with plenty of water and immediately seek medical advice.
• It is advisabie to use hand gloves and goggles.

 *** ถ้ามีจำนวนขอราคาพิเศษ ติดต่อเราได้เลย ***