ดร.ฟิคสิท โปรฟิกซ์ 500 DR. Fixit Profix 500

• An adhesive epoxy resin ratio of 2 parts can be mixed 1:1 and wipe off easily.
• Excellence adhesion. Suitable for a wide variety of paving surfaces such as concrete, stone, metal, wood, gypsum board, plywood, cement, etc..
• Water resistant and without peeling off. Suitable for swimming pool, spa, sauna, bathroom, or where maintenance is cleaner, such as hospitals, food kitchens, operating rooms, etc.
• Use for concrete joint sealant, Pre-cast joint sealant, suitable for both vertical and horizontal application. It can be used effectively even on damp surfaces.
• Quick dry. Reduce the time of delivery.
• Can be used as adhesive for repairing under swimming pool without drain the water out.

 Area of Application :

•  Seamless concrete, trenches as a job Pre-cast.
•  Adhesives, marble and granite tiles, artificial stone, ceramic tiles, mosaics, etc.
•  Adhesive tiles in the swimming pool. Tiles and repair the pool without the water out.

• Used for the 4x4 inch tile adhesive, about 0.5 kg/m if the tile adesive to the larger proportion of the increase
• Concrete joint width depth of 1 cm x 1 cm x 1 cm in length using the Dr.Fixit Profix 500 approximately 0.23 kg.

• The substrate must be clean and free of dust or other loose materals.

• Mix two parts by volume of Dr.Fixit Profix 500 (A) with one part by volume of Dr. Fixit Profix 500 (B) and mix thoroughly for 2-4 minutes, Mix for adequate use within 10 minutes. Apply with putty knife or steel trowel, Pour the mixture into the concrete joint or Pre-cast joint, then I wipe the trowel to smooth uniform surface. If it is not smooth, about 24 hours before proceeding. If using a tile adhesive, spread the adhesive with a trowel cut with triangular notches width minimum 1mm deep at 5 mm. Centre. (The Triangular notches sizes will also depend on thickness of Tile).
• Use as sealants can be used along with the lay down tiling then, or waiting for about 2 hours after apply tiles.

• Maximum joint width 20 cm.
• Minimum joint width 20 cm.
• Do not dilute Dr.Fixit Profix -500 with any solvent in general application.
• Specfications may vary with the effect of mixing on job site. The proportion of mixing the different job site conditions
• When the part A and part B are mixed together and then it within 30 minutes

• Set 10 kg.(Part A 5 kg/gallon, Part B 5 kg/gallon)
• Set 40 kg.(Part A 20 kg/pail, Part B 20 kg/pail)

• Storage instruction maximum 2 years in sealed container kept under shaded dry area

• For the allergic type of solvent or resin. Advisable to wear gloves and goggles while working
• In case of skin contact. wash with kerosene or thinner followed by soap and water