For general porcelain floor tile (granito).Interior and exterior use.
Great for ceramic tile. Interior floor and wall installation
Easy for use, no need for pre-soaking
Net Weight : 20 kg Color : Grey
Information Chalawan composed of Portland cement, special sand and polymer additives. Chalawan produces an excellent bond for interior floor and wall installation.No need to soak the tile before laying.
Installation Preparation For new substrate :The surface must be dry, flat, level and fully cured. It should be free of all grease, oil, dust, curing compounds, old adhesive residues and any other adulterant. Make sure water absorption of the substrate is at normal level. In case of new render or leveling , the substrate should be fully cured for 7 days or 168 hrs. per 1 cm thickness of adhesive before tiling. For old substrate : Clean up the surface with high-pressure jet spray to remove dust, adulterant and any de-bonding tiles. Remove the left water before re-tiling.
Proportion of Mixing Chalawan Tile Adhesive 20 kg (per bag) per 5 L of water or 3 parts of Chalawan Tile Adhesive per 1 part water by volume.
Mixing
Mix Tile Adhesive with clean, potable water thoroughly until smooth with a mechanical mixer at a low speed (≤150 rpm).
Let mortar slakes for 5 minutes before mixing a second time. Do not add water, latex, or additional powder after slaking period.
Application
Spread mortar with flat side of trowel to key-in substrate, and then apply additional mortar to ensure that it cover 100% at the back of tile.
Apply notched side at 60-degree angle in the same direction throughout installation surface.
Recommend to apply the products all over the back of tile to compensate bending, prevent gap under tile that may cause less compressive strength and easily to crack.
After placing tile on the prepared surface, slide it orthogonally to the notched lines and tap in order to maximize bonding.
Tiles can be adjusted for proper alignment within 10 mins after apply the products. Timing may vary depends on temperature. Recommend not to adjust further after setting. Make sure that the products is covered all over the back of tiles. Suitable thickness of tile adhesive on substrate is 2-10 mm.
Curing and Grouting
A minimum cure is obtained in 24-48 hours, depending on ambient temperatures.
For better quality, Crocodile Tile Grout should be chosen to suit each type of tiles. Crocodile Tile Grout has many types and color for each joints and places